How To Maintain Your Hot Water Heater?

by on April 6, 2017

A hot water heater is an essential in houses located in temperate regions. They will provide you with warm baths, clean clothes etc. They are generally expected to last 15 years. But they are subjected to wear and tear over time and you have to know how to maintain them so that you can increase the lifespan of your heater. You could do this by sticking to a great maintenance schedule.  

Regular maintenance will make sure that you have fewer instances for hot water heater repair Kenmore. You can adjust the thermostat to 120 degrees so that it will help you to save up on energy costs. You are able to save up to 5% every time you lower the temperature by 10 degrees. This will also lower the risk of scalding. It is important that you maintain about 2 feet of clearance around the water heater at the minimum. You can also check the manual for specifications. Hot water heaters should be drained to make sure that the minerals and debris that has accumulated inside is flushed out. This will prolong the life of the heater. You will have to carry out this process once a year or a few more times a year depending on the hardness of water in your region.

Manufacturer’s specifications should be heeded to make sure that you appliance is working well. If there are any irregularities, you can call a professional to take care of the hot water heater repair. You can drain the heater by first shutting off the water supply and then turning off the power to the appliance. Leave it for some time to make sure the water has cooled off. You can let it sit overnight so that it has sufficient time to cool. You can then attach a hose to the drain valve. You could then turn the hot water tap and open the drain valve that will cause the water to flow out. You can flush it with clean water by turning the water back on till the water runs clear. Once the water is clear, you can refill the tank, remove the hose and turn the power on. You should also check the working of the temperature-pressure relief valve by discharging it a couple of times. This has to be done once a year. Make sure to look for small leaks from the valve. Every three years, you should examine the sacrificial anode rod. You may have to replace the rod if it is less than ½ inch thick, if it’s coated with calcium or if core steel wire is left exposed for more than 6 inches.